Dosatron D30S
Dosatron D30S
For a complete Irrigation Systems, extensions to your own system or just spare parts all under one roof.
We stock all garden pop-up sprinklers, rotor sprinklers and spray sprinklers, irrigation pipe, porous pipe often known as leaky pipe, tap timers, controllers, manifolds, solenoids, barbed fittings, drip irrigation, micro fittings, border sprays, hanging basket drippers, rain train and oscillating sprinklers.
“Sprinkler Irrigation Systems Ltd” can offer you all irrigation products on a supply only or fully installed. If you require advice on what to do with what, solutions and advice are always available.
The Dosatron D30S Fertiliser Injector is the ideal way to add feed to your lawn and plants.
Inlet 2″ male thread – Outlet 2″ female thread. Flow from 8m3 – 30m3 /Hr. Accurate dosing rates for 0.25 to 1.25%.
Operating pressure 1 to 8 Bar
Very easy to assemble/disassemble the motor (either from the top or bottom, without no tools.
All plastic – no metal parts Easier adjustment
Dosatron D30S Operating principle
Installed directly in the water supply line, the Dosatron D30S Fertiliser Injector operates by using the flow of water as
the power source. The water activates the Dosatron, which takes up the required percentage of concentrate directly from the container and
injects it into the water. Inside the Dosatron, the concentrate is mixed with the water, and the water pressure forces the solution downstream.
The dose of concentrate will be directly proportional to the volume of water entering the Dosatron, regardless of variations in flow or pressure,
which may occur in the main line.
Dosatron D30S Markets
Environment – Hygiene – Water treatment – Vehicle wash – Metal processing
– Food processing – Graphic Arts – Horticulture…
Principal applications
Disinfecting – Cleaning – Fertigation – Phytosanitation – Lubrication –
PH/TH Correction – Sanitation – Flocculation – Vehicle wash…
Dosatron D30S Installation Regulations:
Refer to local water regulations, prior to installing your Dosatron..
To optimize your Dosatron, we advise to:
– Install a filter (300 mesh [60 microns]) upstream, depending on your
water quality.
– Change the dosing seals at least once a year.
– Rinse as often as possible with clear water.
– Turn off the water supply and allow the pressure to drop to zero before
adjusting the injection rate.
– Install necessary protections for excess flow, excess pressure and water
hammer (anti-hammer flow/pressure device).
– Install your Dosatron on a total by-pass line.
Check out our Dosatron D30S Fertiliser Injector in our Online Shop
